Can A Router Table Be Used As A Jointer

It is a money-saving alternative to a dedicated pivotal jointer.

Can a router table be used as a jointer. With the router unplugged use a square and a 12. Is it possible to use a router table as a jointer. Feed it into the router just as you would when using a jointer.

Take note of the spacing between the edge of the bit and the outer edge of the bushing. Heres the answer courtesy of our friends at the Woodworkers Journal. Yes although there will be limitations to board depth based on bit size.

And BTW a taper jig on the table saw or offsetting the fences on my router table for jointing would be completely acceptable alternatives for edge jointing. The only difference is that we have the board laying down rather than standing up as on a true jointer. The technique for making jointing cuts on the router table is very similar to that used on a jointer.

You CAN joint on a router table but it isnt always the best choice especially with thicker lumber. A planer sled works very well for face jointingand I use mine quite a bit. A simple table saw jig will also do an excellent job of edge jointing a board so you may not need to wait until your router table arrives.

Im not trying to make it sound difficult it just requires care. However despite peoples unawareness you can use the Ryobi router table as a jointer. For longer stock lay out your boards on a scrap piece of ply in the order that you want them laminated and clamp them at both ends to your bench photo 10.

The jointer setup on the router table requires careful alignment. Make sure your infeed and outfeed guides are long enough and rigid enough then you can set it up like a jointer laid on its side. The router is good for MANY things partucularly creating detail in lumber in a wide variety of profiles and joinery work are two of the areas it excels in.