Can You Reflow Solder With A Heat Gun

For removing very high pin counts low temp alloy solder can be great like Chipquik.

Can you reflow solder with a heat gun. If a real heatgun point it at the gpu die and do that for a while and see if its better. If youre going to use any no-lead as in part connection not the toxic metal packages like DFNQFN or anything with exposed pad then the hot air rework is very helpful if not required. The heat gun once the solder starts to melt from components will just blow all the resistors capacitors and the likes all over the place and then the thing is definitely 100 a goner.

The four stages are. Or do you recommend I purchase a heat gun and a. If by heatgun you mean hairdryer you might want to get a stand.

Its the only thing you should use for reflow since you can actually. But it is a very time-consuming process. Keep heating until you see the IC level off again.

And the small size vs the heat guns diameter and air flow speed. This would be rather tricky to do with a heat gun IMO. Well not likely -you would damage the chip before you get solder balls to melt - even when removing old solder you should not stay in one place with your soldering gun for longyou should move it.

To Correctly ReflowTM with a heat gun youd need to know exactly what you are planning to reflow and youd need to cover any parts you dont want moving around with kapton-tape. If you can. Some heat guns get a lot hotter than others and some solders melt at far lower temperatures than others.

Able to reflow the GPU successfully. Yes you can reflow solder with a heat gun. I mean a heat gun like hot hot for removing paint and stuff.