How Do I Use A Woodworking Router

If possible use the same wood and bit youll be using on your project.

How do i use a woodworking router. Rather than cutting with a router bit which can sometimes be too powerful a laser is used to burn thru the material. The most basic and primary use of a wood router is cutting holes in wood or routing out to hollow out a hole in a piece of wood metal or plastic while still producing finished edges cutaways curved contours and precisely measured holes. When routing the inside edge of a frame move in a clockwise direction Photo 10.

Also make sure to work with the router in a counterclockwise direction around the top of the workpiece. Next install the pin board into the template and use a straight router bit to cut the pins. If you rout on the left side of the jig the router will tend to wander away from the jig and youll wind up with a run-amuck dado.

With counterclockwise way of working with the wood router the bit pushes the router toward you rather than pulling it away so its easier to control the router and be safer while you work. Rout the inside edge of a frame in a clockwise direction. The correct sequence for routing all four edges of a board is to start on the end grain then cut long grain end grain and long grain.

This act will engage the bit with the wood. For instance if you have a broken table or other piece of wood you can use the router to trace the outline of the original piece and re-create it as many times as you like. Do I want the tightest tolerance possible.

You can also use it to draw and inscribe wording onto a piece of wood as well. Put your safety goggles and put the router on the mark and start pushing the router over the wood. The wood router is a remarkably versatile toolbut it takes some getting used to.

When using a router always make sure you feed your router from left to right this will make sure the blade of the cutter makes correct contact with the wood being machined. Some Important Points on How to Use a Router. Try your technique on scrap wood to get used to the router.