How Do You Solder Electrical Wires

Touch the tip of the soldering iron to the copper wires.

How do you solder electrical wires. If you want you can add soldering resin to the wire filaments. Ad Quality Solder Wire Drawing Machine. If you are not soldering pipes or wires then you may be soldering electronics.

Put the leads through the board and bend them so that they stay dont fall out. The wires will begin to heat up. If this is not the case trim and re-solder the wires.

There is one way to twist wires together for soldering- a horizontal twist that yields a continues length of wire. The connection should not have any uneven globs of solder and the solder should penetrate both wires. The broken wires can be repaired without replacing the entire harness or section.

When doing splices clean the wires by scrapingbrushingsanding solder tin the wires to be joined slide clear heat shrink tubing over one wire lay the tinned ends together and touch them with the soldering iron and they will fuse nicely then slide the clear heat shrink tubing over the joint heat shrink one end pack it with petroleum jelly then heat shrink the other end. Keep the iron in place and touch the solder to the wire until its fully coated. Apply Solder to the Wire.

Hold the two tinned wires on top of each other and touch the soldering iron to both wires. Place soldering iron under the wire. Step 1 - Turn Off the Power.

At some point over the next 2-10 seconds depending on how hot your iron is the wires will be hot enough to melt the solder. First place the solder on the tip to allow for melting. How do you solder electrical wire to metal.