How To Clean A Weller Soldering Iron Tip

Put in the new soldering tip and put the screw back in by turning it clockwise with the screwdriver.

How to clean a weller soldering iron tip. Leads from the 5 conductor cord two wires to sensor two to heater ground. You also can clean your soldering iron tip with a sponge while using it to keep it clean. Electronix Express points out that in order to remove the dirt and debris that accumulates on the tip of a soldering iron it is necessary to wipe it clean with a sponge.

That should be 5x cheaper than to buy the tips from weller. After trying both the sponge and flux to clean the tip of your soldering iron sal ammoniac would be the next step if the others didnt work. This will allow you to clean the device as thoroughly as possible without risking burns.

Unplug the soldering iron and allow it to cool completely. Switch on the Soldering Station or the Iron and Make sure it is Hot Enough. Other soldering stations will vary how the tip is changed and some you actually have to remove the shaft to get at the soldering tip.

You can do this by hand or using a small set of pliers if the locking nut gets stuck. If Ill be sucessfull in outsourcing parts and services. This should lead to a clean shiny tip ready for use for more info see this video.

Turn off your solder iron and let it cool down for 15-20 minutes before cleaning the tip. And if you try to de- solder anything you will damage the tip. If the tip is interchanged with different sizes frequently.

The best tip tinner is your solder--tips should always be coated with a small amount of solder. Let the iron cool before cleaning it. In addition to it.