How To Clean Soldering Iron After Use

For most tip wiping I use a damp cellulose sponge with slits cut in it.

How to clean soldering iron after use. To use the Tip tinnercleaner heat the soldering iron. In November we dealt with removing a particularly tricky oxide called fire scale. How to clean and re tin your soldering iron - YouTube.

Then push it on a clean sponge for cleaning. You can use your fingers to put the new tip on but will need the plyers again to tighten the nut. Good soldering process is important.

When you heat up your work for soldering and reach the temperature at which solder flows you are also creating oxides on the surface of your metal that mar its appearance. Turn it off as soon as you have finished soldering. With the soldering iron at normal soldering temperature stab quickly and repeatedly then immediately add solder the kind with flux in it.

Thrust the iron tip into the tip cleaner a few times till it has an even coat of solder. This step will coat the iron in a mixture of flux and solder. Try not to leave the iron sitting hot on the bench while not in use.

After securing and preheating the PCB and void in a vice or PCB holder you suck the solder off the board by squeezing and releasing the bulb from behind the hole. To apply the tip cleaner first heat the soldering iron. You should push the soldering iron from the tip to down for cleaning.

Did this twenty years ago for a stubborn wart it never came back. Also use a wet sponge for better results. Wipe the iron on a damp sponge to remove the excess.