How To Make Solder Stick To Tip

This is much like aluminum aluminum oxides and stainless more chromium oxides.

How to make solder stick to tip. Clean properly the soldering area and all components as well. Holding the solder in one hand and the iron in the other briefly touch the solder to both sides of the tip. It is essential that the solder continuously flows to the tip to produce a shiny surface.

If you have a soldering station with an adjustable temp control set it to 400 C 752 F. Tip temperature also causes physical changes to the tip through the natural thermal expansion and contraction the metal undergoes during normal use. Add Tip Ask Question Comment Download Step 4.

Touch the seam so that the ball sticks to the solder seam Continue along making the balls as close or far apart as you like. Just bought a soldering iron just to do this and have no experience so any tips would be appreciated. First place its point over the hole On the Solder Side and while pushing down heat up the solder a bit on one side of the needle.

The Needle will go into the hole but the solder wont stick to it. Good luck wetting stainless too. I think that one issue I may have is that I am using solder.

Touch some solder on it and it should melt almost instantly. Put a nice little blob of solder on the tip of the iron. Press the blob of solder into the metal to be soldered.

The heat from teh tip heats up the junction and the solder is fed from the other side of the junction. Also heat the wire first and then apply solder to the area with the tip heating both the solder and the wire at the same time. Wipe the tip of the soldering iron on a damp wet sponge to clean it.