How To Make Soldering Iron With Copper Wire

Ad Quality Solder Wire Drawing Machine.

How to make soldering iron with copper wire. Take the copper tip 1 a piece of 710 cm of 345 mm diameter copper rod and roll the insulator over it on about 4 cm. Materials you will need. Add the proper amount of solder.

Apply flux on the outer part of the pipe and insider the brass fitting too using a small brush. This will heat the wire to allow your solder to melt. Turns should be close but must not touch each other.

Plug in the soldering iron turn it on and let it warm up for 23 minutes. Before soldering starts the bit is heated slightly and then filed to remove the layer of oxide. Wet the soldering station sponge with the water provided in the lab.

Then make two more bends near the center or loop of the first bend as shown in the video so the wire. If you like DIY projects then this video is for youYou just have to woun. The soldering iron is then dipped in flux and then solder is applied on the tip.

Battery Powered Soldering Iron Using Copper Wire for the Tip. If youre just making a spot connection the easiest way would be to trim the end of the tape on an angle exposing a narrow end separate the backing and then use minimal heat to make the connection. You should now prepare the area where the soldering iron will be positioned.

In this instructable I show how to make two styles of 4mm tip the slidey-style and the screwy-style. To prepare bare copper wires especially stranded wires it helps to tin them first. The size of this hole one inch into this wooden block that should ideally be around the copper wires diameter which is around 18 inches.