How To Properly Solder Small Wires

Touch the tip of the solder to the tip of the soldering iron to create a small pool of liquid solder on the irons tip.

How to properly solder small wires. After a few seconds feed solder at. Solder will start melting and flowing to the wire and terminal. Learn How to Solder Correctly.

How to Solder Wires. When you solder items together youll typically be using the hot metal tip of the iron to melt a small amount of solder alloy around and between the components or surfaces being joined. If you did the cable and the tag at the same time by the time the solder properly melted the wire insulation would have started to.

Very thin like a hair enamel coated wire works when using a reasonably small soldering tip. Cut the excess wire. Once cool inspect the union to ensure proper penetration of the solder.

Once the connection evenly turns the correct silver color of solder remove the soldering iron and allow the joint to cool. Protect solder joint with heat-shrink tube as explained earlier in this guide. Remove the soldering iron and wait a few seconds to let the soldered connection cool and harden.

Joint the two disconnected wirings of the PCB board and connect them with a twist. Before touching the soldering tip to the wires tin the tip by melting a small amount of solder on it. Instead allow the iron to heat the wire to the point that it melts the solder.

Then remove your hand and hold the twisted section with a plastic stick. Using a Wire Stripper Strip the Wires to Desired Length. Pinch the wire tip between the solder and the iron tip to tin and flow the wire end.