How To Solder 3 Wires

Set the iron to the solders temperature range.

How to solder 3 wires. You may select the dipping time as per your litz wire AWG size as below table. Bend the end of the wire slightly to prevent the wire from falling out while soldering but do not let the wire end touch any other component lead or another pad on the circuit board. The process for soldering 3 wires together is the same as splicing 2 4 or even 10 of them.

The challenge is holding the wires in place long enough for the solder to cure. Make a solid mechanical connection. Wrap the Entire Bundle With a Separate Strand.

Its not too difficult. When choosing you need to be aware of the lead content flux content melting point temperature and size. Place tip of soldering iron at the middle of the connection to activate the flux.

First you need to strip the wires then add your heat shrink tubing physically connect the wiressolder the wires together and then shrink that heat shrink tubing to make a waterproof connection. Practice before you start in on the bike - get some wire pieces and practice tinning them strip the wire twist the end of the wire to organize the wires and solder it - basically to itself. 60tinpine resin and 40lead.

This method allows for a quick and clean solder job. And allow the solder to melt. Tools need will be a soldering iron heat machine rosin flux solder 3M silicone dielectric grease wire s.

If you want you can add soldering resin to the wire filaments. This process should melt the solder and coat both wires evenly. The solder jar is made up by approx.