How To Solder Electric Guitar Wires

The result would look like Fig 4.

How to solder electric guitar wires. Run the solder over the entire splice so it can melt and travel into the gaps between the wires. Basic Technique Tutorial - YouTube. Next remove the clamp slide the heat shrink over one end of the wire keep it far away from your hot iron and solder the wires.

The tubing will start. Keep the iron in place and touch the solder to the wire until its fully coated. Be sure to trim back any excess wire or solder that might touch the cable upon entry.

Guitar electronics dont need much. This is the basic Volume control wiring. Add the Tone control by soldering a wire from Tab 1 of the Volume control to Tab 2 of the Tone control.

Solder a wire from Tab 2 to the Tip Tab of the Output Jack then solder a wire from the Sleeve Tab of the Output Jack to the back of the Volume pot. I am an electrician and the above is the correct answer except its amperage that determines wire size. Tap the end of the 6337 solder on top of the wire splice so the solder melts down into the wires.

Do tin the wire and the soldering. You might find it easier to use a tie wrap to hold the wires together while soldering. If a splash of solder lands on your guitar it will cause instant damage.

Protect your guitar with card or rags. Apply as little solder as possible here the aim is simply to hold the strands together and provide a surface that solder. This process should melt the solder and coat both wires evenly.