How To Square A Router Table Fence

When using a router bit in a router table a ball bearing guide a fence or both can guide the work.

How to square a router table fence. Before I added the magnet the air blowing out of the front of the router would often lift the insert out of the table. By offering a large table and fence a table-mounted router is better equipped for managing long strips and big bits than a freehand router. To hold the insert down it has a lip that slips under the table on the near side and a door magnet on the far side.

Anyone who loves building things up can agree with me that a router table is a valuable addition to your shop. Use an adjustable square the body should drop into the slot and u can than reference from thereslide the tongue till it touches all the way down the fenceby moving fence untill parallel. Add a C-clamp to help hold the square down.

To set up your router table for jointing first make sure the bit and your router table are perpendicular to each other. A router table fence that is easy to adjust for positioning the cut is a must. Seems it would also be a good idea if you are routing a groove in the edge of a board.

It wont bind as it moves and therefore removes the need for tracks guides or other means of keeping it square. Bill Or use a T square against the fence from the right hand end against the edge of the table assuming its square to the track. Piece of MDFThen rip the fence bottom and front from this piece.

Complete the exercise by fastening using a narrow strip and wait for results. If theyre off the fence will be too. The most important thing to keep in mind when building a router table fence is that it absolutely must be square to the tabletop.

Or make an adjustable gauge from 2 hardwood strips at right angles and a locking knob which can slide in the track and bump the fence at either end of the table to the same dimension from the slot. With the router unplugged use a square and a 12. Using a two-part fence with sacrificial faces will allow you to close up the opening around the bit resulting in far greater effectiveness with dust control an important consideration as any errant shavings or sawdust that comes between the work and the bearing or fence will affect the final.