How To Turn A Hot Glue Gun Into A Soldering Iron

Procure the materials you intend to fuse.

How to turn a hot glue gun into a soldering iron. Place about 1 to 3 mm of solder between the lead and the pad where it will melt against the heated components. Finally glue the AA battery case into the soldering gun case and mount the transformer inside as well with hot glue like this. This is one of the most important tools used in soldering and it can come in a few variations such as pen or gun form.

Wire optional hot glue gun or soldering iron optional Step 1. Welcome to the channel Roman Ursu Hack romanursuhack. It is important to heat the braid with the iron and let the solder in the braid heat the pins as opposed to heating the bridged pins.

When the glue is liquid blot and wipe away with paper towel cotton swab etc. Cut Out a Groove. Soldering irons are the heat source used to melt solder.

Separate the wires on the cut end for a couple of inches 3. Make sure the fan and the light are turned on so you can turn the entire hood on and off from the strip. You can get most of the glue up this way.

Cut the cord off of the glue gun 2. Here you will learn how to do with your own hands homemade wood homemade electronics Christmas c. Roll up the braidwool and lightly stuff it into the tip of the iron.

Otherwise prepare them to be heated. The braid should be laid over the bridged pins and the tinned iron turned almost parallel to the PCB as it is applied to the braid. Un-cure instantly attacked the epoxy and softened it to be able to scrap away.