How To Use A Router Table As A Planer

Drill out a large hole in the center of the plywood.

How to use a router table as a planer. Make multiple passes cutting on the left side of the bit until the edge is jointed. Its wide enough to securely hold the router mounted to an Infinity large router blaseplate 11-58 square. Remember the bit rotation from the top is clockwise so with your straight edge on the left make a push cut and the rotation will hold the router tight to the fence photo 13 - above.

Before planing your workpiece its a good idea to test the alignment of your fence by making a practice cut. The router will be attached to the insert plate with bolts which are inserted into the plate and go through to the router base. Mount your router base to the jig and install a mortising bit or a wide straight bit in your router.

Level the playing field. If you find your router pulling away from the straight edge your direction of feed is backwards. Feed the material from right to left.

An insert that sits below or above the surrounding table can lead to an inaccurate cut or stop a workpiece in mid-pass. The second part of the sled is a bridge that holds the router and rides on top of the sled box. Use the lines to position and predrill holes for four small screws around the hole in a box pattern.

Diy router sled tutorial for the big make your router think it s a jointer easy and adjule diy router planer slab flattening mill woods. Cut the lumber to width plane it to the correct thickness and begin routing the profiles on the face of the stock. Mount the screws with the heads raised slightly.

Turn the table on its side and line up the mounting holes on the bottom of the plate with the correct securing points in the router which you identified earlier. Make sure the insert plate holding the router tool is properly attached and sits in. You can use an inverted table-mounted router to straighten narrow edges.