How To Use Bosch Router Table As A Jointer

Using the right technique you should be able to balance the board on the table thereby achieving a straight edge.

How to use bosch router table as a jointer. We added an edge-jointing function to our router-table fence by simply clamping a piece of plastic laminate on. Hold the router upside down under the table and position it under the insert hole. Once I trim the edge I cut a straight edge on the other side using the table saw and then glue up the two pieces.

Is it possible to use a router table as a jointer. I used threaded brass inserts to secure the legs to the base and I also put inserts in the bottom of the table top so the legs can be fastened just inside the drawers as shown in the first photo above. With the legs mounted and the table on a 35 high surface the top of the router table is 6 higher 45 above the floor.

The maximum length of the board that you mill using the jointer should not exceed 2x the infeed tables length. With individual bits available it takes only a few moments to make a router table a working jointer. Is it possible to use a router table as a jointer.

And its 2-12-inch dust collection port. With the router unplugged use a square and a 12. Place your laminate piece at the left-hand edge of the bit-clearance notch in the router table fence.

First eyeball the fence and clamp one end. Provide easy access to the mains and due power connection and check that the table power switch is operable to be able to activate and turn the tool off when needed. By using a router table fence thats equipped with an offset fence youll be able to dial in the thickness of cut by adjusting the position of your infeed fence in relation to the outfeed side.

The books on routers and other topics are really useful for understanding some of the arcane woodworking terms associated with this must-have tool. Set the fence so the out feed half is even with the cutting edge of the bit. Make sure your infeed and outfeed guides are long enough and rigid enough then you can set it up like a jointer layed on its side.