Will A Heat Gun Melt Solder

I used a heat-gun set to the recommended heat setting to melt the solder and shrink the tubing.

Will a heat gun melt solder. The 280C temperature may be a bit on the low side which can take longer to heat the pads to melting temperature. But even then it is more reliable to solder the wires and then slide heat shrink over it. It is a bit more intricate to explain.

Heat Gun Chandler Tool Dual Temp Hot Air Gun for Crafts Epoxy Resin Shrink Wrap. 380c would be more appropriate. 3M makes ones that are acceptable.

Soldering guns work on low voltage current. BTW a MAPP-oxygen torch from where else HD will burn the copper pipe off. Not much use for solderbrazewelding useful for many other applications.

APPLY HEAT Position the wires into the solder butt connector Use a heat gun at a low setting while continuously rotating the connector Pro tip. Reply 21 on. But others cant and wont be.

If heated enough that the wire is above the melting point the plastice melts and solder pours out. 47 out of 5 stars. In addition hot - air stations are typically non-contact enabling you to avoid damage to other parts of the circuit as you work.

It depends on the solder and the heat gun. Specialty tool either the electric type that is use for electric or electronic work or the externally heated type often used for copper flashing on roofing. Its most suitable for working with soft solder with a melting point below 400C.