How To Clean Microdermabrasion Diamond Tips

Wash and scrub the tips with warm water antibacterial detergent and a toothbrush to remove skin debris from them 3.

How to clean microdermabrasion diamond tips. Pat your skin dry with a cotton towel. The unit sucks in the dead skin cells and a working filter must be in place so that the motor doesnt clog up with skin cells. Taking proper care of the diamond tips will help them last longer.

A device will be. The dead skin cells are eliminated and leave your skin clean and fresh. While wearing gloves carry out the following.

After each use check if there is a clog on the filter. This method of microdermabrasion uses a diamond tipped instrument to lightly abrade the top layers of skin and bring new radiant skin to the surface. Clean the diamond tip end and on the inside of the tip with warm water using the brush included with the Microderm GLO system after each use to remove dead skin cells and debris.

Know what to expect during the treatment. There is also a suction mechanism to lift off the dead skin. It is important to have your face completely dry to allow the microdermabrasion machine to work most effectively.

Step by step demonstration of Filter Maintenance. It is also advisable to start with a low level of suction building up as your skin becomes used to it otherwise you can leave red marks on your skin caused by too much suction. Air dry the tip after washing before inserting back to your microdermabrasion device.

Each treatment will last about a half hour. The skin surface is rough and causes the dead skin to remove easily. How to clean Microdermabrasion tips - YouTube.