How To Solder Bass Guitar Wires

Resist the temptation to blow on the solder to hasten the process.

How to solder bass guitar wires. Solder a wire from Tab 2 to the Tip Tab of the Output Jack then solder a wire from the Sleeve Tab of the Output Jack to the back of the Volume pot. This is the best stuff to use for soldering guitar electronics. There are just two things that will be found in any Bass Guitar Wiring Diagram.

Too much exposed wire can contact ground wires shielded pickup wires or hot wires. No high-tech digital soldering station required. You might find it easier to.

Twist the strands together apply the iron to the wire and then when its hot enough take a little solder to the wire as well. When heat is applied to solder it melts and goes to a liquid state. Standard 6040 rosin-core is best and we prefer smaller 032-062 diameters for guitar wiring.

Just complete the guitar wiring diagram order form with your custom specifications and our designers will do the rest. The solder will melt and flow around the metals. Remove the tip of the soldering iron and the solder placing the soldering iron on its holder to prevent burns to the work table.

The B features buffered inputs and will better match original EMGs. Fits CTS Bourns Fender Gibson Alpha and other pots with 38 diameter shafts. This solder enables you to make solid solder joints without excessive globs of solder.

Plug the soldering iron into the outlet and allow it to warm up. Place the hot tip on the metal and place the solder directly onto the hot metal to secure the solder joint. If you have an output jack in a weird location you may need this to help remove old solder.