Correct Way To Solder Wires

Run wires through grooves and make sure the rods stick out by 10mm at bottom of piece of wood.

Correct way to solder wires. First you need to strip the wires then add your heat shrink tubing physically connect the wiressolder the wires together and then shrink that heat shrink tubing to make a waterproof connection. Correct procedure for soldering 2 wires together. Its vital to use a soldering iron that brings the wire up to temperature quickly.

If your re-wiring your car or truck then this is a MUST Video For YOU. But even in the soldering community theres still room to argue. Connect or solder the electrical wires to rods.

Hold the two tinned wires on top of each other and touch the soldering iron to both wires. Twist the wires together. Ad Quality Solder Wire Drawing Machine.

The core can be soldered in the same way. After making the repair let it cool slightly. Correctly place the wire in the terminal before crimping Center the wire in the terminal and inspect its position prior to crimping.

If you did the cable and the tag at the same time by the time the solder properly melted the wire insulation would have started to melt. You need to apply the heat to the metal part on the plug because that takes the longest to heat and melt the solder. Place the heat shrink over the wire and keep it away from the area to be soldered.

Apply enough solder so that every strand of wire is surrounded by solder. Carve a groove on each side of the 20x40 sides of the wood it should be enough so that the rods fit through the groove. Once cool inspect the union to ensure proper penetration of the solder.